MC for Hydraulic TO bearing

[LarryC5]

Need some advice here. I have a Hydramax Hyd TO and MC kit from American Powertrain for a first gen Camaro.

The problem for me lies in the angle I have to mount Wilwood MC at in order to achieve a direct line from the clutch activation rod to the MC which provides near zero side loading of the plunger assy.

American Powertrain uses a bracket that allows adjustment angle of the MC for better rod alignment. Since I can not move the bracket any higher on the firewall without affecting the one of the 4 bolts that hold the pedal assy to the firewall. Will a 10 degree downward angle of the MC be a problem? This angle seems to provide a smooth and uninterrupted operation of the MC. (The rod angle can move up or down as it attached to the pedal assy via heim joint). Location on firewall seems to be the big issue.

Currently, I have the clutch rod attached to the lowest mounting hole on the clutch pedal assy which puts me at about ~3.25-.5" from the pivot point.

Larry