Need help finding a banjo fitting for my rack and pin

[GregWeld]

Originally Posted by 67XR7

I have a p/s rack kit and I currently have this fitting:

http://www.jegs.com/i/Unisteer/668/8...ductId=1223161

But I need this in 18mm/8AN not 6AN cant find it anywhere I even tried looking at Hydraulic specific sites with no luck. would prefer steel not sure if material will really matter as its for my return line.
OR
I need to come up with a more flexable return hose that looks like "steel Braid"

the reason I need this is because I decided to make up my own P/S hoses for my unisteer kit as Unisteer wants you to run some really short hoses that look like ass when installed BUT the aeroquip hose im using with the hard vinyl inner in size 3/8 or size 6 what ever youd like to call it, is not flexable enough to go over the return side nipple on the supplied pump.SO I need a good looking hose that will stand up to the P/S fluid OR a Size 8/18mm Bajo to get everything done.

Sounds like maybe you could go with an intermediary step and run a reservoir in the system.... so you'd go -6 from the rack low pressure side - to the reservoir with a -6 inlet - and then go from the reservoir with a 5/8" hose barb to the return (usually a 5/8" hose barb fitting) on the pump.