'54 Chevy PU roller

[rusty63ss]

SOLD.

I am selling this truck to raise funds for an educational trip for my daughter.

I am asking $1500 obo.

I will include a 4 bolt 350. Approx 3k on a refresh. 194 double hump heads with umbrella seals, Mallory dual point dist & promaster coil, new at refresh Edelbrock 650 (1406?)carb and intake, new rings, bearings, mild hyd cam, double roll timing chain, high vol oil pump. Work was done 15 years ago. Started and ran fine when I pulled it from the Luv a year ago.

I will also include a T350 trans. Supposably has a B&M shift kit per the PO. No torque converter. I would consider it a core.

This truck had a V8 in it at one time per the PO. Currently has no motor installed. Have SBC headers in the bed.
It has been rewired to 12V at some point with a breaker setup. Some wires are melted.
Comes with three radiators. One stock and two from the large work trucks.
Has a 4 speed top loader pickup tranny.

It does not look like it has ever been restored but it has been modified so a SBC will fit. This will make a great project truck.

I would prefer local pickup from Southern Oregon. But might be able to work something out depending on where you are. Email me @ [email protected] or PM.

Thank you for looking.