Gauging interest in wrecked 68 ls1 project

[HotRod68Camaro]

The car is wrecked, frame is twisted. I was quoted 4k for complete straightening of fame and panels and repaint.

Parts:
MS3 cam and springs
Bo white ported throttle body
SLP MAF
LS6 intake
RAM 980 VDS clutch
D&D Performance t56 tranny
Denny's Nitrous ready 3" steel driveshaft
Moser 12 bolt, 4.11, 33 spline, drilled for 1/2" studs but also has holes for normal 3/8"
Speartech engine harness
AlumRad custom radiator
BRP Rack and pinion/motor/tranny mounts
Kirban shifter
Autometer Gauges
Corbeau seats/5 point harness
Custom 6pt cromemoly (sp?) cage
fuel cell/custom fuel system
rear mount optima
stainless works headers
custom 3" x pipe and bullets
15x8 prostars on rear, 15x7 on front, one is not usable
cal trac tractions bars

All parts i have laying around the house will be included

That is all i can think of for now

Contact at [email protected] or send PM

I use the same handle (HotRod68Camaro) on all other car forums

Thanks

Kyle