67 Camaro project "It Don't Fit"

[Vince@Meanstreets]

Originally Posted by makoshark

What did everyone do with DSE subframe connectors when routing the fuel and brake lines? How did you cross over the connector? Did you fab a channel into the connector or did you just route them over the it?

Also, my Ridetech Airbar on one side has a mm of touching at the back of the floor pan and the other side is about 1/8" away from the back of the floor pan. This is where the forward tube crosses over from frame rail to frame rail. Will this be sufficient or should I address this?

I'd weld in a 1/8" plate to connect the bar to the floor pan.

for the lines I cut in a channel. sits up tighter when the clamps are bolted up.