Gas tanks has been finalized and send to the laser for the first one. I still need to test my design to make sure it won't slow flow due to the height of the filler inlet. The Vent should be large enough to compensate.
Also finally found a CNC tubing bender that isn't insane about his prices. So I drew up the back half of the exhaust and send that and the program off to bend them this morning. This is my first jump into CNC bending so here's hoping its painless. If it is I'm going to be able to cut an easy 200-250 bucks off the cost of the exhaust systems for the Nerd Rods Frames.
The turquoises parts on the frame are revised from the first frames we built and sold thanks to this project and some feedback from guys who wanted to bit the bullet even though I've not gotten as far as I would have liked on this project yet. Nothing major, just subtle things, increasing or decreasing tolerances of different parts or keys. Adding little extensions and there was one slot I forgot to put into a rail but that's all taken care of now.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode