1969 Camaro Build Thread

[lsuguy]

A couple months back I reached out to Clint over at The Shop and had him send me a set of his kick panels and also a package tray. I don't have all of the photos but impressed with the quality. I think they will look great once finished. These photos are just of them mocked up.









And probably the most important thing accomplished was the installation of my Speedtech Torque Arm rear suspension. I don't have a lot of progress photos along the way but here is the almost finished product. I was able to get the housing centered up so that I could pull hard measurements for wheels. I didn't installed the third member yet but will do that and set the pinion angle once I am closer to getting the car on the ground.

I still need to clean up the welds with a flapper wheel and get some primer on them.

















Ignore the "L" sticker. I was just using the rotor to pull the correct measurements for wheels



And last but not least I got my wheels ordered up this week. I changed them up a bit from my original plan. I went with a stepped lip and eliminated the exposed hardware. The wheels are Forgeline GZ3 with transparent smoke centers and polished outer.

I ordered 18x9 for the front and 19x12 for the rear.