Need '69 camaro lower control arm measurment.

[bluespeedball]

So frame is back from powder coating and seams welded. Lowe control arms were blasted and new DSE Delrin bushing pressed in, welded and then ars powder coated. They look GREAT, they look NEW but they dont fit.

The bushings were pressed in correctly (outside pressed in) and the plastic inserts and in the correct way (inside facing out) but the arm appear to be too wide to go in. I likely need 1/8" to get these in. I dont want to force them and have it in a bind but I would imagine they should be a little easier to install.

I am not sure if its the bushings, frame or arms that is the issue. Would anyone have the ability to measure a stock lower control arm from outside to outside arm width? Maybe that would get me in the right direction.

Thanks!