My 68 Camaro Project

[jasonz28camaro]

I took the car to a local shop and just got it back. I was going to have them install new quarters and a floor pan. After they looked into everything a little more they only wanted to patch the lower quarters, both toe boards on the floor pan and the PS floor rather than do full floors and quarters. The shop said it was not a rust bucked and doing it this way would save me money so we went that rout. I hate having a shop do work on the car that I can do but with my work schedule and family its hard making time and trying to get it back on the road sooner than later. With access to both sides of every weld they performed I was good with it and it turned out good.

While it was there they suggested I drop the motor down a bit and I had them raise the tunnel a couple inches to clear the big trans.

The shop got me into a good position to continue and I got some time off to go on vacation with my family. We went to Utah and enjoyed some cold weather and stopped by Kindig It Design where they film Bitchn' Rides. I got limited photos on the showroom floor, no photos were allowed to be taken in the shop so we dont spoil the show.