OMG! Another second gen Camaro, from down under!

[jaba]

Extended rockers are done. They say imitation is the sincerest form of flattery, I hope this is the way Goosesdad looks at this post because I cannot deny that these were heavily influenced by his awesome work.



















The bottoms of these are now match the lowest part of the frame ready for a partial flat floor from the nose of the car to the front of the rear axle.

Only a bit of work to go on the hood / fender gaps and that should be almost all of the major metal work done, besides a rear diffuser and hood vent I plan to tie into everything at a later date.

I've also go to try and decide the best fix to the terrible gap between the back of the trunk lid and the rear tail light panel. Would anyone care to share how they have tidied up this area?