Best bushings for custom A-arms ??

[Bowtieracing]

Thankyou Astroracer!! Those are about 10 cheaper than del-a-lums... And after drilling and tapping grease fitting i believe they will work well on street.

Good tip!

[62fairlane]

on a slight hijack...

I am looking at these bushing for a 4 link for my rear and would like to use a 3.4" turnbuckle rod for them. I can find 3/4" RH studs (suicidesdoors.com) but no leftys!! am I stuck having to turn them out myself? my other option is that since it is a daily driver street car that maybe I would want one end welded so that if the jam nuts come loose my link won't change length on me?

I was planning on some sweged tubes from most likely speedway motors or such.

[race-rodz]

you can get these in LH or RH 3/4"... but only accept a 5/8 bolt.

http://www.speedwaymotors.com/xq/asp...qx/Product.htm

[Larry]

Where did you source the delrin sleeves?