Pontiac LeMans T-37, Project LeManiac

[1FastBrick]

I am not sure were I saw it but I believe what most have done is cut the tunel around were the trans hits the floor and raise it up about 1 inch by adding a strip of metal. Not saying its the best way but if you dont have a roller and dont know how to fab up a new tunnel I guess it would get the job done.

[DDY RCKT]

Originally Posted by 1FastBrick

I am not sure were I saw it but I believe what most have done is cut the tunel around were the trans hits the floor and raise it up about 1 inch by adding a strip of metal. Not saying its the best way but if you dont have a roller and dont know how to fab up a new tunnel I guess it would get the job done.

Someone replied to my thread!!!



Luckily, the kids who (poorly) welded in the replacement floorpans, well, they just overlapped them to the cut tunnel by about 2-3", so I have plenty of preformed metal to work with. I just need to carefully cut it out and patch it back in.

I'm way more concerned about what I'm going to do to the rear of the frame to get the Independent rear installed...