If you noticed in my post I was not assigning blame to anyone and I do not say that the parts were bad at all. In fact I said quite the opposite. The reason for the post is to let people know that are running stock suspension and only choose to run the drop spindles that they might run into an issue with the alignment with there car. There is not mix matching suspension parts in this buildup stock arms stock sway bar the coilovers were the conical spring type and after adjustment the car was not really that low. I think the reason my buddy was pissed was because he did not know that he needed to buy the upper arms to and after paying me to put the stuff in there was obviously going to be an additional cost in purchasing the arms and labor to put them in.
. I did not know that they had any improved or corrected suspension geometry built into there arms. Is there improved suspension geometry built into there arms?? (first generation camaro)
I still stand by what I said that there stuff is really well made and I will tell anyone who asks. I also agree it is very cool to come on here and open the forum for questions about there products.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
