Plumbing on another 69

[bentfab]

Originally Posted by RECOVERY ROOM

You do very nice work that is for sure,Bet you have a better tube bender than mine..lol What is the bike on the table in background?

Thanks Tracey. It's great getting a compliment from another craftsman. If I had to do an interior I would get so pissed off rubbing to peace's of fabric together it would probably start a fire.

I hope to get that super car build one day so I can send it to you. Oh I bet you I have the same bender too !!!

That's my bike that I have'nt touched in about two years.

[Vegas69]

Putting it together and stepping back and enjoying the fruits of your labor is the fun part. Lot's a bread laying on that table!

[bentfab]

[QUOTE=Vegas69;252134]Putting it together and stepping back and enjoying the fruits of your labor is the fun part. Lot's a bread laying on that table![/QUOTE


You nailed that one square on the head. Thanks

[bentfab]

Here's a few updates. Things are looking pretty cool after the plater,polisher,and coater. Still trying to finish up the car. We endded up instaling a full cage also. Being a painted car that's been a little tedius and time cunsuming I'll post some pics of the cage when it's done. Also we got one of the center consoles from the Roadster Shop. We could have made it but at the moment it was just easier to order it. Besides I wanted to check out the Roadster Shops work (good job Phil) Thanks!!! Enjoy

Mark

[bigtyme1]

Looks great Mark, What is the secret to getting stainless lines not to leak? I bought the best of everything and still getting leaks.

[Cris@JCG]

Nice!!

[davin24]

where do you place the brake light switch??
and can you show a pic if you have it.

one more what fittings do you use for the brakes??? they look real nice.

thanks jr.

[GregWeld]

Originally Posted by bigtyme1

Looks great Mark, What is the secret to getting stainless lines not to leak? I bought the best of everything and still getting leaks.

And when all else fails to seal the leak -- because you're a lousy plumber.... You can buy these.

http://www.purechoicemotorsports.com...rod/prd187.htm

[bentfab]

Originally Posted by GregWeld

And when all else fails to seal the leak -- because you're a lousy plumber.... You can buy these.

http://www.purechoicemotorsports.com...rod/prd187.htm

Spillen more beans again !!!!

I stock those as well

[HWY Nova]

Originally Posted by bentfab

That's my bike that I have'nt touched in about two years.

Mark,

Nice tube work on the Camaro..... if that's what you are into.

.... and Tracy, I've see that untouched bike in-person. I tried to get him to work on it, but he is too busy bending tubing on cars.


--Eric