Attention Tri-5 Chevy guys. Ironworks Do-It-Yourself chassis.

[customcam]

[caper150]

Originally Posted by customcam

is that for the guys over at the tri-5 site, cause it sure sounds like they don't like innovatation very much.Great work Roger and Ironworks

[SWAPMEETCRAZY]

Originally Posted by caper150

is that for the guys over at the tri-5 site, cause it sure sounds like they don't like innovatation very much.Great work Roger and Ironworks

Roger --u definitely need to address the tri-5 guys site--they don't no who they
are dealing with ---YET!!--- but we all do!!!! jim

[coolwelder62]

I think those guys on tri-5 site all voted for Obama. Their minds are closed all ready to a new idea.I can weld a little bit and I think I could put that thing togather.The thought that was put into the desgin was the hard part.Nice job.!!

[ironworks]

Originally Posted by SWAPMEETCRAZY

Roger --u definitely need to address the tri-5 guys site--they don't no who they
are dealing with ---YET!!--- but we all do!!!! jim

Thanks I did that this morning, I have been busy this weekend. I went to the Fresno Autorama on friday night and then Dinner with potential customer. Then I got up and went to the Go kart track trying to figure out why things we slower. I found my big ass puts too much stress on the engine and she is just tired. Then I met Gordon Peters and Neil Lea of Rods & Restos at my shop last night for a Tour. They both loved the DIY chassis and may each buy one. Then we went to the Crystal Place for dinner and the Old Buck Owens Songs. Last night when I got home I was tired. So I got up early this morning to Hunt and Peck a response.

Just to be clear, I'm in no ready to sell this kits publicly, I'm just looking for a few guys who want one of these chassis's to build and give me their opinion on assembly and whether it can really be done in a home builders garage.