HRBS Introduces “Shop Bitch” 1967 Nova Build

[Rod Rogers]

This is a great project!
Thanks for documenting it so well. Almost like being there.
Can't wait to see it with color!

[HRBS]

We want to thank Performance Vehicle Works for working with us on a set of their Replacement Dash Bezels. They are made from 18 gauge steel and fit into your stock dash bezel openings. They come standard with the holes cut for 3-3/8 Tach and Speedometer and 2-1/16 oil, water, fuel and amp or volt gauge. They also offer different gauge layouts if you prefer at no extra charge. The bezel comes with 4 upper screw holes predrilled to fit into the factory locations and they even provide a ground stud on the backside of the bezel. The Radio Bezel panel is also made from 18 gauge steel and comes with or without gauge holes. The fit and finish is absolutely incredible !
If you are looking for an alternative to a stock dash bezel or are tired of the plastic competitors fitment issues, give them a shout. They make kits for 66/67 Novas as well as 69-77 Novas !!

[lil427z]

looks first class.
rick k

[RECOVERY ROOM]

Not a bad looking part

[ebncrdr]

Wow that dash is a nice looking piece! price isn't bad either

[HRBS]

We picked her up from my body guy today.
Phase I bodywork / prep is completed.
My guys did a steller job as always.
Back at the shop we masked it off and Raptor lined the bottom side.
Early next week we will take it off the rotisserie and drop in the rear 4 link suspension, bolt on the front clip and deliver it back to the bodyshop for color.

[bigtyme1]

Glad to see some progress buddy.