JCG Restoration & Customs Project Blu Balz

[ironworks]

Originally Posted by Gonzo

We are getting close to having the transmission tunnel done & need to get the motor & trans back in the car.. so need to prep for the next stage.. EXHAUST!! Having to cross 3 inch pipe thru that x-brace is going to be intresting.. So we did a quick layout of what the exhaust will be looking like.. plus it helps with parts list of material required..

So lets see you design it to go over the rear axle.

[Cris@JCG]

U wanna come over & help??

Originally Posted by ironworks

So lets see you design it to go over the rear axle.

[ironworks]

Originally Posted by Gonzo

U wanna come over & help??

I have enough of my own thanks. I wish it was just that easy. Exhaust is pain and no 2 cars are the same.

[Cris@JCG]

I agree Rodger.. But is nice to have something that you can view & change in matter of hrs before you start the fab work on tubes.. I was not even going to attempt the design over the rear axle.. I just wanted to see how we were going to do the X-over box in the center.. Plus it is nice to print a component to scale & transfer it to metal & even guides you where to bend or break..

Originally Posted by ironworks

I have enough of my own thanks. I wish it was just that easy. Exhaust is pain and no 2 cars are the same.

[bentfab]

Originally Posted by Gonzo

I agree Rodger.. But is nice to have something that you can view & change in matter of hrs before you start the fab work on tubes.. I was not even going to attempt the design over the rear axle.. I just wanted to see how we were going to do the X-over box in the center.. Plus it is nice to print a component to scale & transfer it to metal & even guides you where to bend or break..

Buy the time you do that I'm already at the mufflers thinking about going over the rear end.