JCG Restoration & Customs Project Blu Balz

[Cris@JCG]

I agree Rodger.. But is nice to have something that you can view & change in matter of hrs before you start the fab work on tubes.. I was not even going to attempt the design over the rear axle.. I just wanted to see how we were going to do the X-over box in the center.. Plus it is nice to print a component to scale & transfer it to metal & even guides you where to bend or break..

Originally Posted by ironworks

I have enough of my own thanks. I wish it was just that easy. Exhaust is pain and no 2 cars are the same.

[bentfab]

Originally Posted by Gonzo

I agree Rodger.. But is nice to have something that you can view & change in matter of hrs before you start the fab work on tubes.. I was not even going to attempt the design over the rear axle.. I just wanted to see how we were going to do the X-over box in the center.. Plus it is nice to print a component to scale & transfer it to metal & even guides you where to bend or break..

Buy the time you do that I'm already at the mufflers thinking about going over the rear end.