My new 69 project

[Sandbagger]

Originally Posted by Jay Hilliard

Dan uses Tig for 99% with everything he does. You can get the rods from most welding supply places.




I used AMD for everything. Its alot nicer than others and heavier gauge. I have a NOS trunk lid and bought an AMD and the AMD is heavier by a few lbs. Go check out Dan and his shop. Excellent work, sends pics constantly, great communication.

I have been in collision shops for 20 years . Never seen it used . Kinda sad really . I have cut parts off that use it good stuff .

Less heat ? I know it grinds easier than mig welding .

[Jay Hilliard]

Originally Posted by Sandbagger

I have been in collision shops for 20 years . Never seen it used . Kinda sad really . I have cut parts off that use it good stuff .

Less heat ? I know it grinds easier than mig welding .

You are correct. Per Dan, it does use less heat and is easier to grind. I am not very familiar with it myself.

[tones2SS]

Looks great Jay. Really good! You must be getting jacked up seeing the pics.

[bonecrrusher]

Damn - looking good!!

[Jay Hilliard]

Gapping trunk lid to qtrs

[waynieZ]

It takes a lot of work to get them right, but its worth it in the end. Nice progress.

[coolwelder62]

Sombeach that look's great.This is going to be a top notch build.