exhaust size ?

[speedjohnston]

If you have ground clearance issues, you can check out spin tech. They have oval pipe for added clearance. They also sell mufflers, bends, transitions and made to order custom pieces.

[SuperB70]

Or you can go it same way that I did: I fab an 4" exhaust on 2 gen camaro with 2 set of mufflers. A pair of bullet race mufflers and big (cant remember Fm model) mufflers that go's in trans tunnel next to driveshaft, mufflers are it they own place under back seat and tails are coming under rearaxle with a little twist and coming out rear around original fuel tank. Owner later wanted tails to be 4.5" stainless.

Pictures: in here

There is no pic of those ss tails, for curves I used Patriot exhaust 4" madrel bend U-s, used 3 of those.

At first time I did an 3" straight pipe, no curves and round mufflers at the back, now with this new we have more clearance. This is a street car, had no problems with exhaust at all. Tune is strong but nice.

We have bigger and more powerful engine so 3" was too small, pipes where all to way colored blue and where boiling hot even at the far end after little "driving" but its just right for you.

[SDMAN]

Originally Posted by speedjohnston

If you have ground clearance issues, you can check out spin tech. They have oval pipe for added clearance. They also sell mufflers, bends, transitions and made to order custom pieces.

----------------------------------
Thats exactly what I did. 4" oval pipe headers to mufflers, 3.5" tailpipes. Several custom pieces made by Spintech. One was a pair of 4" round to 4" oval transition bends. And the angle of the bend was specific to my setup. Thats how we got oval collectors on my custom headers. Spintech was great to deal with. Stuff got made right the first time and turnaround was very fast. I never would have gotten the car as low as it is without the oval pipe.

[dubbleu]

You need 3 inch and no more if they are bent right!! Chech out Stainless Works you wont be sorry, its some of the nicest stuff out there!