AWD front end parts

[exwestracer]

Originally Posted by Motorcitydak

Who makes control arms like that? I just looked at the AFCO site and was going to get em thru there. Is there somewhere better?

Also, the AFCO ones have a 3/16 flange. Not 3/8 like I thought for some reason. I still could use 2 1/4 plates on that and the 3/16 in the middle giving the ball joint 11/16 of steel to ride in

Just a couple examples.

http://www.howeracing.com/p-7564-cro...pe-4-bolt.aspx

http://www.detroitspeed.com/1967-196...30101-uca.html

I'm sure there are others out there.

(Actually I just went back and looked at AFCOs arm. They are a better design than they used to be. I haven't dealt with theirs in about 10 years. Those shouldn't need a lot of reinforcing either...)