1969 Camaro Restomod Project Thread

[will69camaro]

Passenger Side Door:
Very little rust in this panel.

Looking at the bottom right of the panel above, you can see this small spot of rust.


Driver Side Door:
Little more rust but not terrible. Will be patched.

Previously filled side mirror hole. Will be punched out and mirror installed.

Rust in bottom front corner (similar place as other side).

Leading edge of the door hit the fender (misaligned). Will be fixed.


Passenger Front Fender:
Looks pretty good, had a dent pulled out in the past, will be patched.

Closeup of the bondo repair work on lower side behind wheel.


Driver Front Fender:
Little rust but again it will be patched.

Closeup of the rust on the lower section behind the wheel.


Dash:
Cant find the pic but it has a nickel size rust spot on the dash sealing area for the front windshield below the vin. It will get patched.

Roof:
Pretty good shape, little rust in the window channel and some surface rust/dents. Will be patched where necessary.

Front window channel (approx 1ft from passenger a-pillar).

Closeup of the same spot showing a small spot of rust.

[will69camaro]

Floors and rocker panels:
Overall very good shape. Small patches in rear floor near the drains to fix pin hole rust (not bad)
Passenger side rear floor drain.

Driver side rear floor drain.

Driver side rocker panel. SOLID.



Passenger side rocker panel. SOLID.



Hole in trunk pan for previously modified tank (patching and going different route).

No pics after blasting but shifter hole(s) will be patched with an auto tunnel panel and will cut a single hole for T56.

Trunk lid:
This will be replaced. LOTS of bondo on it.


Header panel:
Looks good, no dents, rust, etc.



Front Valence:
No rust, but a few small dents that will need to be fixed.




Vent panel:
No pics (can be seen in some of the above), but all is good. No real rust or dents.

That's all the detailed updates I can give for now.

William

[waynieZ]

Thats a lot better than mine was.