[IMG]
[/IMG]
Got a start on the chassis jig yesterday and pretty darn pleased with it so far. I have four bolt adjusters on the legs. I wanted to do minimal welding on the two beams so built the supports this way. I have to do a couple cross supports but I may just bolt some angle iron on each end where there already holes...to save welding and risking deforming the beams.
Have to do leg braces yet also...
I like the notches in the beams...a 2x4 fits in perfectly for quick cross supports. Also will see if I can pick up some 1-1/2" tubing I can tack in place.
I left the supports a little long and set them both at the centerline of the wheelbase...figure that might come in handy for placing the jigs for the uprights.
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Threaded Mode