GEN II 70-78 Camaro gauge mounting solutions from New Vintage - Lateral-g Forums

marks914 · #1 10-20-2011, 04:01 AM

Ay interest at all or should we drop this one?

skatinjay27 · #2 10-20-2011, 01:17 PM

Quote:

Originally Posted by marks914

Ay interest at all or should we drop this one?

have you checked the interest on nastyz28 ? on a pro-touring site i dont think this will move much because honestly the stock gauge panel looks dated in a pt build.

djorgensen3 · #3 10-20-2011, 02:43 PM

Yes definitely try NastyZ and also Team Camaro. You should have a lot of interest on both of those sites. You might also be asked if you have, or will have, anything available for the later 2nd gen dash.

BonzoHansen · #4 10-20-2011, 08:11 PM

Try nastyZ28. I think that looks great.

marks914 · #5 10-21-2011, 09:00 AM

Thanks guys,
just to let you know this is not a stock replacemet but a mount to install our aftermarket and custom gauges in the stock location. That way you can keep the stock plate that actually fits and retain the controls. You can run any of our 3-3/8 and 2-1/16" gauges.
Ill have to se what it takes to be a sponsor over there
Mark

1976camaroguy · #6 10-21-2011, 12:45 PM

I like it, mostly because I am working on a 5.3 swap in my 1976 camaro and could benefit from something like that.

Right now I plan on using factory guages and a cable x controller to convert the signal to my stock cable driven speedomenter.

Is there anyway you could make the shifter opening accept the stock shifter indicator? Looks like there is plenty of room. I'm am using a 4L60e in my car and have already bought the OD shifter adapter kit with the center mount indicator.

I would like to try and keep that if all possible

djorgensen3 · #7 10-21-2011, 02:32 PM

Well I threw a link on nastyz to this thread. Check out the interest over there in only few hours.

http://www.nastyz28.com/forum/showthread.php?t=226139