GEN II 70-78 Camaro gauge mounting solutions from New Vintage

[marks914]

Thanks guys,
just to let you know this is not a stock replacemet but a mount to install our aftermarket and custom gauges in the stock location. That way you can keep the stock plate that actually fits and retain the controls. You can run any of our 3-3/8 and 2-1/16" gauges.
Ill have to se what it takes to be a sponsor over there
Mark

[1976camaroguy]

I like it, mostly because I am working on a 5.3 swap in my 1976 camaro and could benefit from something like that.

Right now I plan on using factory guages and a cable x controller to convert the signal to my stock cable driven speedomenter.

Is there anyway you could make the shifter opening accept the stock shifter indicator? Looks like there is plenty of room. I'm am using a 4L60e in my car and have already bought the OD shifter adapter kit with the center mount indicator.

I would like to try and keep that if all possible

[djorgensen3]

Well I threw a link on nastyz to this thread. Check out the interest over there in only few hours.

http://www.nastyz28.com/forum/showthread.php?t=226139

[70rs]

YES......please make this. And in the shift indicator area put blinkers (one above the other, arrows) a neutral light, a high beam light and park brake light.

I will buy one when they are ready. And gauges too.

Thanks jorgensen, I found the link on nastyz.

[marks914]

Hi Guys,
I think that the stock shift indicator can be installed or we can install a custom indicator panel:


Right now the hold up is we need to get a car in our shp for final fitment.

[syborg tt]

Mark Put me down for one. Here is my e-mail so I can get you payment information as this is exactly what I am looking for.

[email protected]

[70rs]

Any progress on this? If I was closer I'd let you use my 70.