This is MY 67 Camaro

[makoshark]

Well, it shouldn't take a day or so to get here

If all goes well, they will be installed tomorrow

[Sonar Chief]

sanding the quarters! I didn't get the door prepped, IAW POR15 if you let it dry overnite you have to rough the skin with a scotch brite and then you can topcoat. I'll rough it up this week and take it to work and get some black on the door.
So plan B, get the quarters down to metal and see if there are any surprises under all that paint. Chemical and mechanical stripping started and I almost finished in one day ... Just some touch up left and when I get the wheel houses going and the patch I can start body working the rear half.


Needed two rounds to get it down to metal

Still needs some work

Driver's side looking better
So ... not too exciting but it's progress, I put the trunk lid on for trial fit - pretty good fit.
Not bad for 45 year old quarters
Thanks for looking

[coolwelder62]

Look's Good, I am lovin your progress.

[Sonar Chief]

Originally Posted by coolwelder62

Look's Good, I am lovin your progress.

Thanks for noticing ... little at a time and then she's done!

[waynieZ]

Nice progress. They look really good , you must have felt happy seeing those in that shape once the paint was all off.

[Sonar Chief]

Originally Posted by waynieZ

Nice progress. They look really good , you must have felt happy seeing those in that shape once the paint was all off.

Thanks ... I was very happy to see the quarters in bare metal knowing I don't have to replace them

[Bucketlist2012]

Originally Posted by Sonar Chief

Thanks ... I was very happy to see the quarters in bare metal knowing I don't have to replace them

A little at a time......then you will be Done...Keep at it..