Lokar Shifter boot help.

[RECOVERY ROOM]

Put your ring in place then take a very sharp drill bit and push hard to drill holes thru floor,

place boot over shifter and get it at the look you want ( short or Tall )

place ring over edge of boot an use a hole finder (awl, scatch awl, pick ) to locate holes

run screws thru holes, If there is material showing around ring carefully trim with a blade.

stand back and admire your work

[protour73]

^^^^ I was hoping the "King of Interiors" would chime in with great advice, thanks Tracy. There you go Brian!!

[WicKeD_SS]

Originally Posted by RECOVERY ROOM

Put your ring in place then take a very sharp drill bit and push hard to drill holes thru floor,

place boot over shifter and get it at the look you want ( short or Tall )

place ring over edge of boot an use a hole finder (awl, scatch awl, pick ) to locate holes

run screws thru holes, If there is material showing around ring carefully trim with a blade.

stand back and admire your work

Great! Ty I just wanted to make sure I did it right so thanks for the info.

[RECOVERY ROOM]

Glad to help, I only check in you guys every couple days to see these type of questions, So if im slow to help with a answer, You know why

[79 Camaro]

On my lokar boot I notched the boot around the screw holes and then using contact cement glued the boot to the underside of the ring. Doesn't move around even when I take it off.

[RECOVERY ROOM]

Thats what I do with my custom leather ones