Project 'Too Much': 1969 P1800S - soon to be P1800 GT

[daemon2]

Still working on the turbo headers, will move into the plumbing and controls soon.
A few pics:


Drivers side, I am mounting the turbo's back near the firewall, the headers ended up looking like ram horns. The engine bay is tight so this is where I found room.


I am supporting the header near the turbo with a support welded to the bottom and bolted to the block, also have hangars for the turbo that are not mounted yet.




my welds are more consistent now, stainless is nice to work with.

[Royalworks]

Its been a while since i have been on here. Pretty awesome stuff!

[WSSix]

Headers look fantastic!

[daemon2]

I have removed all the mechanical bits from the door handles and am replacing it with electronics. I modified the door handles to accept the illuminated buttons that actuate the door latches.






This last image was a test fit before all the machining was complete.

[WSSix]

That's a neat idea!

[MacPiper]

Great idea with the door handles. Will they work with a proximity key to allow activation?

[daemon2]

Originally Posted by MacPiper

Great idea with the door handles. Will they work with a proximity key to allow activation?

Thanks, and yes they exterior release is only active when the alarm is deactivated. It could work the same way with a prox key

[daemon2]

Slowly putting together the firewall and planning plumbing.

Rad in:


Wilwood Pedals test fit:


And some eye candy under the hood:

[coolwelder62]

Lookin Good.!!!!!!

[MacPiper]

Getting closer now. Looks great!