1969 Camaro tru-turn

[jlwdvm]

SO even though Wilwood mentions that the rotors are +0.38", they aren't all that more wide than the Baers (which are considered baseline for this discussion)?

[Rod P]

Originally Posted by jlwdvm

SO even though Wilwood mentions that the rotors are +0.38", they aren't all that more wide than the Baers (which are considered baseline for this discussion)?

dude that's 3 times more than the 1/8 that someone measured earlier?

0.38" is alot, just because you wrote it short doesn't make it short that's .380 thousands that's almost 1/2 and inch...actually closer to 3/8

if its 0.380 you need to adjust for that, so a 6.00 inch backspace would be better

[jlwdvm]

38/100 is the same as 380/1000. My point was that even though I am using Wilwoods that are supposed to add 0.38" to track width, but they are only 1/8" wider than the Baers that Ride Tech used. Baers must not be 0 according to our measurements. The measurements you gave off of the frame gave everybody a baseline (as long as there car is measured with no shims, at ride height, etc).

[glr0212]

I am at 15.5+ I measured from the base of the control arm mount rather than the control arm cross bar. so that is worth at least another 1/4" or 0.250"



We measured from here