2010 Camaro 14" rotors on a 12-bolt. How?

[HEEP]

Tobin,
From what I can see on your site, I think I may be interested in this kit from you.

GM 10/12-BOLT, ø330mm C6 Z51, PARKING BRAKE

Just wondering if the calipers I have will work..

Thanks,

[Apogee]

Originally Posted by HEEP

Tobin,
From what I can see on your site, I think I may be interested in this kit from you.

GM 10/12-BOLT, ø330mm C6 Z51, PARKING BRAKE

Just wondering if the calipers I have will work..

Thanks,

If your caliper assemblies are complete, then you could use them with the 330mm [13.0"] C6 Z51 setup, however you would need the C6 Z51 pad abutment brackets (PABs) to properly position the calipers with respect to the larger diameter rotors. The only setup that will work straight up with the C5(Z06) caliper assemblies will be the 305mm [12.0"] kits they were originally supplied with.

Tobin
KORE3

[HEEP]

Tobin. Thanks for the info. Can you tell me the dimensions of the hole spacing from the mount to the caliper bolt? Trying to make sure of what I actually have.

[Apogee]

Originally Posted by HEEP

Tobin. Thanks for the info. Can you tell me the dimensions of the hole spacing from the mount to the caliper bolt? Trying to make sure of what I actually have.

128mm [5.039"] is the center to center dimension for the caliper mounts.

[HEEP]

Tobin,
Thanks for the info. I will measure when I get home. I found a picture today of them side by side. That will help also.