TR6060 fit in 69 ?

[69dragracer]

I did not have to cut the tunnel any for it to fit, just had to do some clearancing near the front of the tunnel near the firewall seam. I did shorten my frame stands to lower the engine in the subframe and also used CPP adjustable plates to adjust the engine position. I would have liked to go lower on the engine to improve drivetrain angle, but had to compromise due my dynatech headers hanging so low.

If I was to do it over I would use the speedtech tunnel piece just to make fitment even easier.

[Angry]

We dont have that luxury here, as cutting the Tranny tunnel would need an engineers report to register the car.
I need to be sure it'll fit without cutting it up...