Rust question

[Vince@Meanstreets]

That is light but its deep. Sanding it may push it deeper.

I would use a rust dissolver/remover such as http://www.harborfreight.com/http-ww...6431-html.html

then wipe down with some metal prep.

[Rick D]

Originally Posted by Vince@MSperfab

That is light but its deep. Sanding it may push it deeper.

I would use a rust dissolver/remover such as http://www.harborfreight.com/http-ww...6431-html.html

then wipe down with some metal prep.

Not sure on this one Vince?? I'm not a big fan metal prep either

I would take a small hand sandblaster and just blast it clean. That's what I do for areas like that.

Those converters can leave behind residue that can work its way back up after paint. Ask me how I know

Oh I've never done it but have seen it a few times at resto shops with issues.

[Rick D]

I bought this little guy a year ago and it work well for small spots and keeps them mess to a minimum.

http://t.harborfreight.com/abrasive-...bag-60308.html

[ma73z]

Thanks fellas, I'll try the spot blaster first and see how it does and go from there.

[Vince@Meanstreets]

Not sure if you had acess to a blaster. That would be the best way but it takes a while.

Rick, those are rust removers and not to be confused with converters or sealers. I left a rusty bracket in this stuff over night and it came out looking like an NOS piece after wards.

There's a few videos of the stuff being used. One where a guy it treating a hood section. He made a dam with tape and plastic and let it soak. A perfect technieque for a roof panel.

A vid of it used on a coil spring.