DSE Quadralink vs Speedtech torque arm - Lateral-g Forums

Sheck44 · #1 07-09-2015, 03:36 AM

Terry, oh ya forgot to mention that as well ... full 3" over axel was VERY important to me as well, wanted to avoid dumps at all cost

**Ketzer** · #2 07-09-2015, 12:24 PM

The new Chassisworks T/A looks really really nice.....

Decline · #3 07-09-2015, 01:03 PM

Quote:

Originally Posted by Ketzer

The new Chassisworks T/A looks really really nice.....

^^^This
I love all the little detail stuff they built in for alignment and adjustability.
Plus that billet watts link is pure automotive pRon

Curious to see a install pic with exhuast routing around the watts link tho
I have a TCI torque arm. Up and over exhaust routing was tricky and I only have 2.5" tubes. It vibrates on the roll bar occasionally even after i wrapped it with DEI.
One day I will go LS and get a clipped corners gas tank to gain enough room for 3"

**Ketzer** · #4 07-12-2015, 05:06 PM

Quote:

Originally Posted by Decline

^^^This
I love all the little detail stuff they built in for alignment and adjustability.
Plus that billet watts link is pure automotive pRon

Curious to see a install pic with exhuast routing around the watts link tho
I have a TCI torque arm. Up and over exhaust routing was tricky and I only have 2.5" tubes. It vibrates on the roll bar occasionally even after i wrapped it with DEI.
One day I will go LS and get a clipped corners gas tank to gain enough room for 3"

I also have the TCI TA and 3" over the rear. It is tight but no rattles.

Terryd · #5 07-09-2015, 04:23 PM

[QUOTE=Sheck44;610783]Terry, oh ya forgot to mention that as well ... full 3" over axel was VERY important to me as well, wanted to avoid dumps at all cost

Very nice Sheck! I see you are using a 12 bolt rear. Any comment on how it attaches?

Sheck44 · #6 07-10-2015, 04:09 AM

Not at all Terry, had a good local welder weld up the brackets in the proper spots and easy as pie bolting it all in in my garage.

Took me about 3-4 hours to bolt it all in, now I know what I'm doing I could probably do it in 2 hrs

Steve

Vega$69 · #7 07-10-2015, 05:33 AM

I had a TCI Torque Arm on my LS7 Car and liked the ease of installing and the way the car handier. Shocks will make a difference in ride.

We are in the process of building my kids car now with the same TA.

I have a DSE Quadralink in my new car. Haven't driven it yet so no opinions.

I will say the install in extremely labor intensive and also requires modding the rear seat frame.