DSE Quadralink vs Speedtech torque arm

[Ketzer]

Originally Posted by Decline

^^^This
I love all the little detail stuff they built in for alignment and adjustability.
Plus that billet watts link is pure automotive pRon

Curious to see a install pic with exhuast routing around the watts link tho
I have a TCI torque arm. Up and over exhaust routing was tricky and I only have 2.5" tubes. It vibrates on the roll bar occasionally even after i wrapped it with DEI.
One day I will go LS and get a clipped corners gas tank to gain enough room for 3"

I also have the TCI TA and 3" over the rear. It is tight but no rattles.