1969 Camaro Restomod Project Thread

[will69camaro]

Made some more progress but another roadblock keeps the engine trans out for now.

Got the pilot bearing. Confirmed it matched the input shaft and installed it.




Bellhousing front cover installed (didn't do this first time before flywheel so had to rework...)


Flywheel installed.


Clutch installed.




Installed slave to complete checks on if I needed a shim and saw this...wtf! It's for a c5. New one arrives Friday...


Since I was stuck on the motor. I moved to something else. Installed the power door locks.






Then moved on to some arts and crafts to lay out the dash before I start making cuts. This isn't finalized and looking for comments/suggestions still.






Dash items.
Upper portion left to right:
AC vent, Racepak, racepak mode buttons (1&2), AC vent

Lower portion left to right:
Headlight, line lock, Holley input, (gap for steering column), start button, AC controller.

I am looking at adding a 4th button on the left of moving them one spot to the right to give room for the windshield wiper control when I get it.