I wish hahaha my intentions are always good I swear, unfortunately I did not even get a chance to look at it. I am going to pick up some bottle jacks to act as an extra set of hands to hold it in place and try to figure out where it is hitting. Thanks for checking back Josh!
I wish hahaha my intentions are always good I swear, unfortunately I did not even get a chance to look at it. I am going to pick up some bottle jacks to act as an extra set of hands to hold it in place and try to figure out where it is hitting. Thanks for checking back Josh!
http://www.pro-touring.com/threads/1...rack-car-build
Check out post #15. Mine was off too (maybe not quite as far as yours). I had to do a lot of massaging to the trunk pan (original) to get clearance for the front bar. I also used a bottle jack on each side to help push the cradle up to close the gap and then hold it in place while welding. My car also has original frame rails.
well I seem to have gotten as close as I can. I think I am going to have to pay a shop to finish this install. Can anyone recommend a good shop that has real world experience with the exact product or install. looking in CT NY MA RI area.
thanks
well I seem to have gotten as close as I can. I think I am going to have to pay a shop to finish this install. Can anyone recommend a good shop that has real world experience with the exact product or install. looking in CT NY MA RI area.
thanks
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
