36 chevy truck

[tigwerks]

I should have my new oilpan tomorrow so I can finish mounting the engine and transmission into the frame. Oil pan is roughly 1.5" too deep and didnt allow the trans pan to sit flat on the table. Trying to have everything sit flat with the frame rail.





Still waiting on my collectors to be finished and shipped which should be in the next few days and then i'll have everything to start the manifolds.

[Dr G]

Love the theme of this project. Would like it more with fenders. With no fenders it might give the impression of a T-bucket?

[tigwerks]

Made some temporary caster/frame stands to get the frame on the ground until i get the suspension and wheels mounted. It was time to get the frame off the table to make future work easier. Pretty happy with how my 1st frame came out though. Need to finish the transmission crossmember still. Just purchased a zl1 rear diff so hopefully i can get some sort of cool billet aluminum mount setup drawn up and machined.

[raustinss]

where did you get the rotors ...? did you get a deal ? im piecing my ZR1 brakes together and need all four rotor$ . everything else i have already

[tigwerks]

Friend of a friend got them for me for a good deal. Ya the rotors are $$$$$. Still searching for the rears.

[tigwerks]

Carbon fiber dash arrived yesterday. Unfortunately not completely satisfied with the product. But once installed, hopefully people wont not notice the flaws

[Centerforce]

Cant wait to see the setup with those BW turbos!!