Who has this set up in 1st gen camaro

[jimmythehand]

I have the speed tech front clip and torque arm, the speedtech motor mounts/plates, and holley oil pain. I had to reverse the mount/plates to get the clearance i needed from the unisteer, but it is really close.

[72Z/28]

Originally Posted by jimmythehand

I have the speed tech front clip and torque arm, the speedtech motor mounts/plates, and holley oil pain. I had to reverse the mount/plates to get the clearance i needed from the unisteer, but it is really close.

Could you please explain what you meant by reversing the mounts/plates in your case.

[72Z/28]

Ok guys I found out how the autokraft engine mounts installed in Evade Camaro.

http://www.pro-touring.com/threads/5...uot-Evade-quot

The engine mounts are flipped ( not installed as per the photo shown in Autokraft website).

So is this how it is supposed to be installed to prevent the oil pan flange from touching the rack & pinion inlet and outlet ports?

[nicks67ca]

Protouring sub frame installation instructions on the bottom of the page.

http://www.speedtechperformance.com/...=prod/prd8.htm

[72Z/28]

Originally Posted by nicks67ca

Protouring sub frame installation instructions on the bottom of the page.

http://www.speedtechperformance.com/...=prod/prd8.htm

Thanks Nick. The instructions will definitely help with the installation.

Hopefully someone will chim in regarding the engine mounts installation as I have seen two ways of installing them. Not sure about tje reason though.

[Blake Foster]

i got your email and replied to it. did the info i sent you help?

[72Z/28]

Originally Posted by Blake Foster

i got your email and replied to it. did the info i sent you help?

Hi Blake

Unfortunayely I have not received any email from you yet. Might have been sent to a different email address. Will appreciate sending it again