I was thinking of plugging the MC one at a time and heard a lot about the phoenix V-12 bleeder. Hate to spend $200 or the price of the MC. Maybe chuck Wilwood and go elsewhere.
I was thinking of plugging the MC one at a time and heard a lot about the phoenix V-12 bleeder. Hate to spend $200 or the price of the MC. Maybe chuck Wilwood and go elsewhere.
Plugging one side at a time is a good idea. It doesn't sound like the master is the issue at this point.
Are you running stainless brake lines? They can be a b*tch to seal. Maybe try some conical seals.
Not SS just steel. I do have a wildwood Proportional valve inline to the rear should that be adjusted one way or the other? I am also going to shorten the rod today maybe its not coming back far enough?? also no leaks at all. Thanks
Not SS just steel. I do have a wildwood Proportional valve inline to the rear should that be adjusted one way or the other? I am also going to shorten the rod today maybe its not coming back far enough?? also no leaks at all. Thanks
Prop valve should be adjusted for max rear brake. The direction you turn it is counterintuitive so look at the knob carefully. AMHIK...
ok after 1 1/2 hrs of bleeding the brakes the old fashion way the fronts have no air in them at all and work with very little pedal. The rears just when I think they do not have air in them I try to stop the rear wheels to stop at idle and I can stop them but it requires the pedal to the floor. Not good I rebleed them and the same thing. I think I will stop for a while and see if a shop around here has a good bleed tool and can do them. My head is flat from beating it against the wall
I've had this problem recently. I was getting the very fine bubbles with my vacuum bleeder. I removed the bleeders from the caliper, and put red wheel bearing grease on the threads of the bleeders liberally. I did this at each corner, and had a perfect pedal in 45 minutes. The ultra fine bubbles were coming from the bleeder screws threads. I went and purchased a new vacuum bleeder during the process, thinking I had an issue with the bleeder. Just about drove me crazy...
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
