Brakes not stopping very good !!

[DOOM]

Originally Posted by Ketzer

I thought I read on here somewhere that they (carbons) have to have a good bit of heat in them to work well... but I don't remember anybody saying they had to have heat to work period.

I thought so to but I've put plenty of heat on them and still the same.

Originally Posted by Vegas69

It sounds like you may have air in your master cylinder. It may need re bench bleed. I personally never liked the 7/8 due to more pedal travel. I always thought a 15/16 would be perfect and I think they make it now. I ended up with a 1" on mine and preferred it over the 7/8. It was a higher firm pedal. It did take some leg.

Assuming your caliper pistons and master cylinder have been calculated correctly.

I will look into that Todd Thanx

Originally Posted by Musclerodz

Does it have a wilwood master on it? There is a recall on 7/8 bore masters.

Chrysler!!!