Brake rotor centering

[WSSix]

Those values are actually pretty close to what I have for pinion angles now. The issue is my rear end if higher than the rear of the transmission so the drive shaft is down in front. The solution is to raise the trans more. I'm not sure I have the room due to my headers though.

I didn't want to get into it just yet as I'm waiting to see what the Drive Shaft Shop has to say, but I'm getting really concerned with some things about my build compared to what others have had to do with their similar builds. This whole car is a learning experience for me. I'm worried I may have missed or done some critical stuff wrong after all. We'll see what happens. I hope I'm just over reacting.

Thanks