70 Camaro - Boise, Idaho

[Goosesdad]

I've had the door bars sitting on the shelf for a couple years thinking I would help my old bones from having to crawl over them 7 bazillion times but decided it was time to cross this off the to-do list. I did save about 3 bazillion trips...!

[Sandro's 1969 502 Camaro]

Originally Posted by Goosesdad

I've had the door bars sitting on the shelf for a couple years thinking I would help my old bones from having to crawl over them 7 bazillion times but decided it was time to cross this off the to-do list. I did save about 3 bazillion trips...!

I cant even imagine the amount of time that has gone into this amazing build so far. This wil be one bass ass car when its done. 👍

[Goosesdad]

Engine bay bars welded in, will put the top tube in later.


Silly detail here but this stamped cowl support flexes quite a bit at the bottom because the factory didn't leave enough of a lip. I added a few small pieces of metal and then just a little fun with the dimple die.


Installed the hood latches.

Lots of work ahead of me to get the gaps tightened up.

[glassman]

Geez louiz!!! "The foundation in this one runs deep young skywalker".

Soo good. Thanx for posting...

[alex n]

Nice

[waynieZ]

Good fix.

[Goosesdad]

Originally Posted by kevin_l

Fantastic metal work and planning. Some how I over looked this thread. You're attention to detail is amazing. Keep up the good work.

Originally Posted by glassman

Geez louiz!!! "The foundation in this one runs deep young skywalker".

Soo good. Thanx for posting...

Originally Posted by alex n

Nice

Originally Posted by waynieZ

Good fix.

Thank you!