2010 SS Camaro Leather Seats in 69 Camaro?

[dhutton]

Originally Posted by slimjim

I am running the standard SS seats but may upgrade to the recaros.
We notched the running boards, removed the original seat pans and mounted the seats as low possible.

I didn’t do anything this sophisticated. Just added some small extensions to the floor pans with correct mounting nut locations. I cut the locating features off the bottom of the tracks. I had to remove a skooch from the rear outside track to clear the seatbelt mounting bolt hole. One of my goals was to retain the stock mounting holes in the event that I could not get these to work.

Jim’s solution is superior but I think it would exclude the Morris three point belts I wanted to use. His method would work better with the TMI console.

Don

[slimjim]

Originally Posted by dhutton

I didn’t do anything this sophisticated. Just added some small extensions to the floor pans with correct mounting nut locations. I cut the locating features off the bottom of the tracks. I had to remove a skooch from the rear outside track to clear the seatbelt mounting bolt hole. One of my goals was to retain the stock mounting holes in the event that I could not get these to work.

Jim’s solution is superior but I think it would exclude the Morris three point belts I wanted to use. His method would work better with the TMI console.

Don

My method was really a result of installing the 5th gen dash, trans tunnel and center console. something to keep in mind depending on what console you use.