Angry Johnny's 69 Camaro Build

[Rodknock]

You just never know what lurks under the primer that someone else did. Till you get down to a clean slate, you just never know.









Little MAP gas torch works well for taking filler off. Just have to be careful not to get the panel too hot.





Clean slate. It was suggested on a FB page that I should replace the quarter panels, but, I said no way!! After all the issues I had with front sheet metal fitment, there was no way, I was going to deal with full quarter panel replacement. Besides these are still the original panels, and the door gaps are perfect. Somebody did a decent job of getting that passenger side pulled out with a slide hammer, it just need the holes welded shut. No big deal. I think I counted 54 holes total though