Inner (DSE) and outer wheel houses + trunk extensions so I could get the quarter skins mocked-up to figure out my axle/housing length. Then I bought 80' of 1.75" x 0.120" DOM tube, nice bender and cheap notcher. Started making bars.
The Following 2 Users Say Thank You to Kmelander For This Useful Post:
Inner (DSE) and outer wheel houses + trunk extensions so I could get the quarter skins mocked-up to figure out my axle/housing length. Then I bought 80' of 1.75" x 0.120" DOM tube, nice bender and cheap notcher. Started making bars.
what kind of tube bender is that i would love to invest in one for my own project
what kind of tube bender is that i would love to invest in one for my own project
I got the JD2 Model 32 I believe. It works great. Would be better with hydraulic power though. If/when I ever need to do it again, I'll add the hydraulic power to it.
The Following User Says Thank You to Kmelander For This Useful Post:
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
DSE minitubs and rear frame tubes
Hybrid Mode
