1969 Camaro Restomod Project Thread - Lateral-g Forums

cjfirstgen · #1 12-04-2020, 08:26 AM

Quote:

Originally Posted by will69camaro

I considered a floater but didn’t want to fully redo rear and brakes. And potentially affect offset for rear wheels. Too much potential impact. Really wanted to use the floater style with c6/7 rear hubs and make use of rear wheel speed sensors as well, but lose the benefit of being able to pull the axle if keeping 35 splines (vette hubs are 33).

Maybe in the future.

Understood. Just to clarify. Wheels don't have to change at all. Axle tube is cut to length for overall same width.

**will69camaro** · #2 12-04-2020, 09:17 AM

Quote:

Originally Posted by cjfirstgen

Understood. Just to clarify. Wheels don't have to change at all. Axle tube is cut to length for overall same width.

Understood and still not happening this go round

Being that i didn't break a 31 spline axle, just gave it some twist, i think 35's will have no issue staying in one piece.

**WSSix** · #3 12-04-2020, 07:07 PM

I'm glad you confirmed it was twisted. I sat there looking at the screen for a minute wondering if my eyes were playing tricks on me, lol.

rickpaw · #4 12-07-2020, 08:34 AM

It was good seeing you at the track Will. Too bad we couldn't hang around longer.

Sorry about the carnage. Glad you were able to save the Forgeline.

**will69camaro** · #5 12-07-2020, 09:19 AM

Quote:

Originally Posted by rickpaw

It was good seeing you at the track Will. Too bad we couldn't hang around longer.

Sorry about the carnage. Glad you were able to save the Forgeline.

Yea man was good to see you too! I didn't get to hang out too much with anyone, was a busy day for sure.