2nd Chance Camaro - Let the Project Begin

[syborg tt]

Since I will be planning and running the wiring in the car it is time to put everything wiring in it's own tool box. So years ago I bought two of these toolboxes from Sears in a close out sale for $60.00 each assembled. They have been sitting in my warehouse for years and I have finally found the perfect use for one of them.

Trust me fitting up this folding shelf was not planned and the fact that it was a relief.



All of this is going to find a proper home.

[syborg tt]

Now that I know how the trans fits and the fact that I will need to redo the trans crossmember. I am going to remove the trans so I can install
the fitting for the trans cooler lines. Plus it will open up the are under the car so I can get some work completed under the car.

I will be replacing these fittings so I can use the Holley PFT line with AN fittings



Good thing Mike was over to help.



Don't be afraid we have a plan...



Oddly enough I couldn't convince Mike to be under the rack while I lowered it down.



Perfection !!!





Opps



See you in a couple months.

[syborg tt]

Looking forward finally installing the Holley EFI tank.



Since the rubber isolator strips were in my garage attic and there was some duct tape nearby. I taped the straps so I wouldn't scratch up the tank.



I needed to open up the end so I could hang the straps.



All taped up and ready to install.



Since I plan to install an access door I took a few measurements so I could figure out where to cut the hole in the trunk floor.



This does not look like it is going to be fun to do by myself.





Time to call for back up.

[syborg tt]

Don from Village Auto stopped by and measured up my driveshaft for me.



It was shortened and balance and now it's off to the Powder Coater.



Just need to take it apart first.







Off we go to Pro-Tek Powder Coating so I might as well bring more parts.





Still can't find Chunky Bars so I found a substitute.

[syborg tt]

The plan here is to find a suitable location for the Holley Fuel Filter Regulator.





I plan to use this clear hose for mock up as it is roughly the same size as the -6 PFT line.



This looks like a possible location.





Time to drill a few holes.



Mocking up the fuel line.