66 Chevelle LS7 Protouring in Sweden

[Jimbo1367]

Originally Posted by warhawkchevelle

Thank you very much.
They are 18x12s with 335/30 in the back and 18x9s with 255/30 in the front.

They are about 550$ per rim now I believe.

That’s pretty cheap. The wheels sizes fit perfectly.

Thanks,
Jim

[warhawkchevelle]

Originally Posted by Jimbo1367

That’s pretty cheap. The wheels sizes fit perfectly.

Thanks,
Jim

Yeah, quite affordable. Unfortunately when our Swedish government have taken their piece by taxes and customs they are almost up to double that

[jarhead]

love the updates, looks fantastic

[Jimbo1367]

One last question (for now, LOL) what kind of rims and model? Those are Weld wheels, correct? I think those would look good on my 70 Camaro if I tub it

thanks,
Jim

[warhawkchevelle]

Originally Posted by Jimbo1367

One last question (for now, LOL) what kind of rims and model? Those are Weld wheels, correct? I think those would look good on my 70 Camaro if I tub it

thanks,
Jim

Hi!
These are Weld S71s with black spokes.

[Jimbo1367]

TYVM Sir

[warhawkchevelle]

Well, got started with a new much better tunnel over the weekend.
Will do the sides tomorrow and then take out engine and trans to finish it of and make the panel towards the firewall

[warhawkchevelle]

Engine and trans came out yesterday, before I put them aside for a while I decided to get the hydraulic throw out bearing set at spec .200” for my dual disc clutch.

Installed the clutch and started measuring, had to remove some material from the plate between bearing and transmission to get correct play.

[warhawkchevelle]

Got the tank mounted and a fuelfilter before the hoses got routed.
When the motor gets installed I just have the hoses into the rails and back to regulator left to route.

Been busy a while when building a 489 bigblock for a buddy, hopefully that one is gonna be done in a couple of weeks.

Next weekend is a snowmobile trip with some buddies :up: