Project "Redfire" 69 Camaro - Lateral-g Forums

redfire69 · #1 06-10-2021, 06:39 AM

A couple pics of the dash wiring harness done, cluster installed with disconnects. Steering column, shifter, VA heater, and BIMs wired.

**WSSix** · #2 06-11-2021, 07:40 PM

Glad you're back on it! Good luck with it.

redfire69 · #3 06-15-2021, 06:45 AM

I couldn't find an off the shelf package available with the brakes I wanted, so I built it myself. 3.50 31 splines, Moser housing and axles, Wilwood 4R 13 inch brakes with internal parking brake. Gotta love bolting together all new parts!

redfire69 · #4 06-16-2021, 08:35 AM

Front brakes installed: Wilwood 6R C6 - 14 inch rotors. Completely worth the 6 week wait!

redfire69 · #5 06-22-2021, 09:10 AM

A member asked me about how the Anvil front valance fit and I realized I hadn't shared what I did here. Below are the pics showing how I modified a stock lower valance to support the grill behind the Anvil valance. I added tabs on each side that get sandwiched between the headlight support and front inner wheel well for strength. I also did cut off the lower valance support from the bottom of the hood latch support. The grill gets installed before the Anvil valance as the valance incorporates the front bumper.

redfire69 · #6 06-22-2021, 09:11 AM

A couple more pics of the grill support and front valance:

redfire69 · #7 07-13-2021, 07:57 AM

Got the brake lines and DSE leafs mounted and ready to go!