Gt-1

[Panteracer]

Thanks for the Cam tip...will see what my engine
builder says and like I always do get another opinion
Hoping to build this so it is fairly reliable.. thinking
8600-8800 rpm should be enough but who knows

Bob

[Panteracer]

I met with my engine builder and went over
the old Hutter Sb2 engine... cam was bad in several
areas.. lncorrect spacing on lobes ate it up... going
to use Bullet Cams to make a new one and a 4-7 swap
and he also mentioned 321... Crank is a nice piece, lightened
and journals narrowed.. rods just above a Honda rod..
Pins are a little small so might have to leave compression
at 11-1 but make up in cam timing.. parts are not cheap
but to go 8600-8800 you need to get the good stuff

Bob

[WSSix]

Good luck, Bob!

[Panteracer]

While waiting on the engine parts, etc I am installing a new
seat, moving pedals etc...I am 6'2 1/2" so need to open it up
I am also going to get the car wrapped to try and calm down
the yellow color so playing with paper etc to see what works

This is some progress

Bob

[Panteracer]

Bought a restored 70's Homelite Tractor to use when
I need to move the Race car in and out of the shop
Getting too old to push things around... my 6 year old
Grand nephew has a new toy

Bob

[camcojb]

That's cool!

[Panteracer]

Gt-1 is wrapped.. still waiting on pistons and valves
Due in a couple of weeks

Bob

[OLDFLM]

Love the 70-73 nose bird on the hood!